• LGC1B-CROSS ROLLER LGC1B - AirTAC
• LGC2B-CROSS ROLLER LGC2B - AirTAC
• LGC3B-CROSS ROLLER LGC3B - AirTAC
• LGC4B-CROSS ROLLER LGC4B - AirTAC
• LGC6B-CROSS ROLLER LGC6B - AirTAC
• LGC1A-CROSS ROLLER LGC1A - AirTAC
• LGC2A-CROSS ROLLER LGC2A - AirTAC
• LGC3A-CROSS ROLLER LGC3A - AirTAC
• LGC4A-CROSS ROLLER LGC4A - AirTAC

Feature description

With self-adjustment ability

X-shaped (45°-45°) of curved groove on cross section design makes it self-aligning. Even small misalignment exists on the mounting surface,

this design can help absorb it and maintain high precision, smooth and stable linear motion.

 

Low profile,High rigidity,equal load on four direction design

The 45-degree contact angle design of the four rows of steel balls and the raceway allow the steel balls to achieve the ideal two-point contact,

and can withstand the action and reaction force from the radial and lateral direction. Meanwhile, pre-load can be applied to increase extra rigidity if necessary.

Reduce the combines height of the slide block and the slide rail, shorten the length of the slide block, to achieve miniaturization.

 

Interchangeable

Because of the strict control on manufacturing porcess, the dimensional accuracy is stable and within the set tolerance.

Beside, the ball retainer design can prevent steel balls from falling out. Therefore when assembling, blocks are interchangeable within the same spec and

still maintain consistency of pre-load and accuracy.

 

 

Precautions on use

 

1.Block disassembly

With ball retainers aand a dustproof cover, normally the balls are prevented from falling out when block is removed from rail.

However, if obliquely rail into blocks or quickly assembled or disassembled, there is a risk for balls of falling out.

Please carefully assemble the linear guide or use plastic rails to assist.

 

 

2.Plastic rail installation

A plastic rail is equipped for individual block set. Please do not remove plastic rail whenever it is not necessary.

If plastic rail falls out and needs to be reinstalled, press the dustproof covers with fingers and install slowly to prevent balls from falling out due to misalignment of plastic rail.

 

 

 

3.Caution

※ Parts may slide out if linear guide is put unevenly. Please be careful.

※ Hitting or dropping linear guide could have huge effect on accuracy and lifespan even though appearance may remain intact. Please be careful.

※ Do not dissemble linear guide as external objects may enter blocks and cause accuracy problem.

 

4.Lubrication

※ Linear guide have been treated with anti-rust oil during production. Before use, wipe the rail and treat it with lubrication.

※ Do not mix lubricating oil (grease) with different properties.

※ After lubrication, move block back and forth for the length of three blocks long and repeat at least 2 times to ensure there is a grease file on rail.

 

5.Use

※ The operating environment temperature should not exceed 80℃, and the maximum temperature should not exceed 100℃.

※ Do not separate blocks from rail whenever it is not necessary. If you need to separate them, please use plastic rails to prevent steel balls from falling out.

 

6.Storage

※ When storing blocks, rails or linear guide set, please be sure that anti-rust oil is well applied and product is well sealed as well as placed horizontally.

    Avoid humidity and high temperatures environment.